Fluid Film Black CNASBL 1 Gallon Can Non-Aerosol
FLUID FILM BLACK® is a penetrant and lubricant also used for corrosion prevention. It is a non-toxic, long lasting, thixotropic liquid that has been used for over 50 years in the highly corrosive marine environment of ships and offshore drilling rigs. More recently they have been introduced and successfully utilized in the Automotive and snow handling industries as a vehicle undercoating. The wet barrier creeps and migrates into tight seams and into the metal chassis to provide corrosion protection from salts and brines. The addition of FLUID FILM BLACK® allows customers to protect their vehicle while restoring a rich black color to the chassis or cover existing rust.
FLUID FILM BLACK® is formulated from specially processed wool-wax, highly refined petroleum oils and selected agents to provide corrosion control, penetration, metal wetting and water displacement. The long-lasting product contains no solvents, will not dry out and will penetrate to the base of all metals, providing corrosion protection from both natural and industrial atmospheres. Heavily corroded and/or frozen parts such as nuts, bolts, shafts, etc. that would normally be damaged during maintenance, can be salvaged by applying FLUID FILM BLACK®.
Specifications
Appearance: black colored liquid
Viscosity: Brookfield HBF, 70 ° F
#2 Spindle at 2 RPM: 10.5 - 13.5 reading (16,800 - 21,600 cps)
Flash Point, Bulk Liquid: ASTM-92 Cleveland Open Cup 405°F minimum
Non-Volatile: 89% minimum (3 hours @ 220°F).
VOC. CARB 310 AS: Less than 25%, NAS: Less than 1%
Specific Conductivity: Less than 10 -9 ohm/cm @ 1 mHz.
Specific Gravity: 0.875 - 0.885 (less propellant)
Effect on Rubber (ASTM D-471 @ ± 158°F 70 hours): None on neoprene and buna-n. May cause swelling on non-oil-resistant rubber goods.
Effect on Paint : None on most painted surfaces
Effect on Aluminum: No pitting
Extreme Pressure ASTM D-2782 Timken Method: Fail load - 15 pounds.
Wear Prevention – Characteristics (ASTM D-2266 Four Ball Method): 40 Kg., 1200 RPM for 1 hour @ 167°F. Results: Scar diameter of 0.49mm.
Repaint ability: Contain no silicones. It is recommended that surfaces treated with FLUID FILM® AS or NAS be hot water or steam detergent washed (120°F), whichever is most effective.
Corrosion Protection ASTM D-1735 Humidity Cabinet: Passes 50 days
ASTM D-1748 Humidity Cabinet: Passes 30 days
MIL-C-16173 (Corrosion Requirement): Grade 2 -Soft Films. Meets & exceeds salt spray requirements.
Water Replacement: Displaces water from all metal surfaces (MIL-C-23411, Paragraph 3.6).
Toxicity: Non-toxic, LD-50 greater than 3 grams per kilogram. Non-irritating skin response. Very slight irritation to the eyes. (Toxicity tests performed according to standard methods by an independent laboratory).
Warning AS: Extremely flammable. Contents under pressure. Do not puncture, incinerate or store above 120°F. Keep from open flame.
NAS: Combustible. Do not incinerate.
WARNING: This product can expose you to chemicals, which are known to the State of California to cause cancer and, which are know to the the State of California to cause birth defects or other reproductive harm. For more information, go to