Wacker Neuson PG3A Dewatering Pump
Centrifugal dewatering pumps are the value alternative for keeping jobsites dry. Wacker's PG dewatering pump series has been designed to handle the removal of relatively clean job-site water. With its self-priming centrifugal pumping action and overall compact size, the pump is ideal for the contractor with the need for temporary water removal.
Features:
- Cast iron impeller and volute are wear resistant for long life and minimal service.
- Pump out vanes on back of impeller reduce debris accumulation and downtime while allowing greater productivity. Carbon ceramic mechanical seal teamed with reliable four-cycle engine with low oil shutdown provides for increased operating life.
- High strength lightweight diecast aluminum housing increases the years of trouble-free pump life.
- A heavy-duty protective frame provides convenient carry handles while adding extra protection for the pump.
- Self-priming high performance pump capable of handling solids up to .25 inch (6,5mm), ideal for jobsites with relatively clean waters.
Specifications
Suction & discharge diameter: 3 in
Length x width x height: 20 x 16 x 18 in
Operating weight: 69 lb
Shipping weight (including packaging): 75 lb
Shipping size: 21 x 17 x 19.5 in
Max. head: 98 ft
Max. discharge: 264 US gpm
Max. suction lift: 25 ft
Solid size capacity: 0.25 in
Engine Type: air-cooled, 4-cycle, single cylinder, gasoline engine Honda
Displacement: 9.9 in3
Max. power output: 5.5 hp at 3,600 rpm
Operating power: 5 hp at 3,600 rpm
Fuel tank capacity: 3.8 US qt
Fuel consumption: 1.9 US qt/h
WARNING: This product can expose you to chemicals, which are known to the State of California to cause cancer and, which are know to the the State of California to cause birth defects or other reproductive harm. For more information, go to